Toyzuki Scx10 II kit version G10 chassis Kit
ATTENTION: All international orders must contact me for shipping cost. Please include complete mailing address.
The kit you've all been waiting for! This chassis kit is for the scx10.2 kit version. Axial did a great job with the new design, but like always I couldn't leave it alone. The heaviest component it the rig is the motor and as well as the stock kit performed I couldn't bring myself to get used to the motor being raised higher than the old kit and also being in the back of the truck. Designing a kit for the rtr would have been easier, but I wanted to get the hard work out of the way first. The new toyzuki version moves the motor closer to the frame than the old version to free up some driveline clearance on the other side for the new high pinion style axles.
The motor mount now houses the first 2 gears of the kit version transmission and the transfer case houses the stock transfer case gears in a new configuration that can be run as an overdrive for the front or you can swap the driveshaft to the other output if your not into that sort of thing. Also with the smaller gear sets in these things, the entire case fits below the chassis rails for an easier interior install.
A few other things changed from the old kit also. The new kit is assembled with nylock nuts and m3x10 button head screws. No more one of a kind hardware that you can't replace with out me sending you more. The servo winch location was moved to the rear behind the axle so the weight hangs well below the center of gravity and you can use an internal or external spool winch. there is still a mount up front for an internal spool winch laid on its side, but the front is also a great place to mount a small lipo or your electronics above or below the servo plate.Instructional thread can be found here!http://www.rccrawler.com/forum/axial-scx10-ii/573201-toyzukis-scx10-2-a.html